Aastra 600d for Aastra 800 and OpenCom 100 User Guide EN Manual do Utilizador descarregar pdf (Página 75)

Telephoning

Ending a Call

If the subscriber you are speaking to ends the call, the busy signal for your telephone

is switched off after a few seconds and you can be reached again. This also applies

when you are connected via headset. The time interval until the busy signal is

switched off is configured by the system administrator. All other connections are

ended after 20 seconds when the receiver is not replaced.

Accepting Calls

When there is an incoming call, an event window with information on the call appears

on the display and the display illumination is switched on.

Calls are ended by pressing the end key briefly.

Press the call key.

… or

When “Auto answer” is activated (see page 131) – remove the mobile

unit from the charging station.

optional:

The ring tone and/or vibration alarm are switched off, you can,

however, still accept the call.

… or

Reject

/ Press softkey (alternatively: end key) The call is rejected. The caller

hears the busy signal.

… or

Press softkey briefly and select one of the menu entries offered, please

refer to Incoming Call Menu starting on page 75.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 163 164

Sem comentários

Aastra 600d for Aastra 800 and OpenCom 100 User Guide EN Manual do Utilizador Página 75