Aastra 600d for Aastra 800 and OpenCom 100 User Guide EN Manual do Utilizador descarregar pdf (Página 136)

The Device Menu

134

times. Then an alarm call can also be made during a call (depending on

mobile unit).

Other systems: The “Hold” function may be generated using other

codes on other systems. The respective system documentation provides

information on suitable programming.

Alarm auto answer: You can configure whether a call from any call number is

automatically answered during a prealarm. No matter what the setting,

calls from the alarm call number or the SOS emergency call number are

automatically accepted and prealarm ended.

Alarm tone: Prealarm can take place with/without an alarm tone on the

mobile unit. When the alarm tone is activated, it is signalled with

increasing volume.

Handsfree in alarm: You can configure whether an alarm call is done in

handsfree or receiver operation. This setting also applies to the emer-

gency call via the SOS/emergency call key.

Pre alarm: You can set the time interval to go by until the emergency call

number is dialled. During this time, there is a ring tone (alarm tone) sig-

nalled at increasing volume (unless deactivated). During the prealarm,

the alarm can still be cancelled (Off, 10 sec … 60 sec).

Repeat alarm: This is the time interval after which another prealarm including

subsequent dialling of the alarm call number is executed, e.g. because

calling the alarm call number was cancelled (Off, 5sec… 240sec).

Mandown

Status: Shows whether mandown alarm is switched on or not. Press the

Edit

softkey to switch on or off.

Delay: You can define the time how long the device is allowed to be out

of the vertical position without triggering a prealarm (1 sec …

60 sec).

No movement alarm

Status: Shows whether no movement alarm is switched on or not. Press

the

Edit

softkey to switch on or off.

Delay: You can define the time how long the device is allowed to be

motionless without triggering a prealarm (10 sec … 60 sec).

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 163 164

Sem comentários

Aastra 600d for Aastra 800 and OpenCom 100 User Guide EN Manual do Utilizador Página 136